dubaipax.blogg.se - Vcds coding download

The Airbag module must be bolted properly to the floor with sufficient battery voltage present before attempting to communicate with or code a new module.

Any problems with crash sensors, airbags or igniters should be repaired before trying to install and code a new controller.

Always save a complete prior to removing the original Airbag controller.

New Airbag Controllers in many VW/Audi vehicles contain a Soft Coding of all zeros from the factory and must be coded once they have been installed in the vehicle. The following procedure details how to code a NEW Airbag (SRS) Controller after it has been installed in a vehicle. They have an electro-mechanical switch that deploys the airbags, somewhat like the hammer and trigger on a gun, it cannot be "recocked" and you should stay far away from any people or companies who claim to be able to "reset" a used airbag controller. When airbags have deployed and there is permanent crash data stored, which cannot be cleared conventionally by clicking, the airbag controller must be replaced.

The Suggested Coding and Manual Index will only work with these professional-grade Interfaces. Make sure to download and install the latest version of VCDS before performing this procedure while using a HEX series Interface. As always, you should refer to a Factory Repair Manual for your vehicle!ĭue to liability concerns, Ross Tech does not offer assistance for installing used airbag components. Ross-Tech is not responsible for any damage or problems that may result from following these instructions.

The following Tech Tip demonstrates the basic steps for Index based Airbag Coding only.